The Hidden Guide

Do you have wild screen? if the answer is yes then you should read this ,
you may noticed that in some channels that doesn’t support wild screen two big black lines in both left and right side

See Example

so now how to remove this two lins in the side? that is easy thing to do

Right Click on the mytheatre window and choose Setting then General Setting
From the General Setting window under the Diplay Tab Check on Optimize Video Size For Wild Screen

Now After Doing this step you will noticed that the picture now is diplayed in the full screen mode

of course there is disadvantage for this method first thing you ‘ll noticed is that on top and bottom side there is little bit cut in the picture that is normal i think because not all channels support wild screen

but any way that is better that the two big black lines on the left and right side

Now enjoy watching all channels on the wild screen

i showed before how to configure and scan for channels using mytheatre, now i’ll show how to optimize mytheatre to get best performance , so let’s begin

1-right click and choose setting/General Settings
this will open the general settings window

2-from the settings window choose AutoGraph
first thing to do here is to change the video and audio Decoder to get the best picture
from my expernice i found that cyberlink video/sp Decoder is the best video Decoder to use in mytheatre ,
so choose cyberlink video/sp Decoder from the menu
then we need to choose an audio decoder the best one to use is Ac3fliter

Note that you can choose any Video And audio filter you want ,i tried many filter and i found that thes setting will get you the best picture in the most channels

3-another thing to change it make mytheatre run little faster , under the Expert tab
uncheck Use CPUs and leave only mark at the first box

that is all we need to to to start using mytheatre , in the next post i’ll show more settings

most of people uses DVB Cards on their pc , so they can watch and record cabel and sattleite channels ,
and there is many programs you can use i’ll start with the most famous and powerful program it’s mytheatre

so i’ll start with some of the basics in mytheatre
after you install mytheatre we need to configure the LNB and start scan for channels

1-right click on the main program window from the menu choose setting/LNB/DisEqc setting

2-click on the Diseqe buttom from the window appers put you LNB Setting (you should use you own setting based on you LNB and Diseqc)
after you finish click do it now then click ok

3-then choose ku-lin (thes also depends on you LNB type in most case ku-lin is the most use this days)
then click apply now

4-on the right corner of the window we going to scan for the channels
click sel all to select all transporter then click scan

and that all we have to do

in the next post i’ll show how to configure mytheatre for the best performance